![]() ![]() All centrifugal pumps contain an impeller. ![]() Friction losses are included in dynamic suction and dynamic discharge head.Īn impeller is a rotating disk containing vanes coupled to the engine's crankshaft. Friction losses result in reduced pump output and can be minimized by used the largest and shortest hoses possible. Friction losses always occur when a liquid is flowing through pipes and becomes greater as the length of pipe increasesĪnd/or the diameter decreases. ![]() The additional pressure or head created at the pump due to the friction of the liquid flowing through the hoses, pipes, fittings, etc. The maximum pressure (at zero discharge) of any pump can be determined by multiplying the maximum head by 0.433. Notice how the diameter of the pipe doesn'tĪffect the pressure value. If you attach pressure gauge at the base of a pipe 100 feet tall pipe filled with clear water, you would measure 43.3 psi. The pressure exerted (in psi) at theīase of a column of water is 0.433 x Head (in feet). Pressure and head are directly related when referring to pump performance. Pressure is often included in pump performance curves. Pressure is force per unit area and is usually listed in psi (pounds per square inch). The dynamic suction head plus the dynamic discharge head. The static discharge head plus the additional discharge head created by friction or resistance (usually referred to as losses) from the liquid flowing through the hoses, fittings, sprinklers, nozzle, etc. The vertical distance between the pump's discharge port and the point of discharge, which is the liquid surface if the hose is submerged or pumping into the bottom of a tank. Practical dynamic suction head lift to less than approximately 26 feet for any pump. As a result, an atmospheric pressure of 14.7 psi at sea level limits Atmospheric pressure enables pumps to lift water. The static suction head plus the additional suction head created by friction from the liquid flowing through the hoses, fittings, etc. The vertical distance between the pump impeller and the surface of the liquid on the suction side of the pump. Refers to the height of a column of water that can be supported by the pressure or vacuum exerted at the pump. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |